Pro-Ject Audio Systems
Pick it MM E
The Pick it MM E is an entry-level moving-magnet phono cartridge made by Pro-Ject Audio Systems. It uses a low-mass system with a miniature neodymium generator magnet, a conical diamond stylus, and a resonance-optimized, highly damped ABS body weighing 5.5 g. Specifications include 3.8 mV output at 1 kHz, 10–20,000 Hz frequency response ±2 dB, 1.8–2.2 g tracking-force range, 47 kΩ recommended load resistance, and a 1/2-inch mounting standard.
MSRP
—
Original list price not on record.
Used market
No tracked sales yet
MSRP to used market
Price history will fill in as sales are recorded.
Specifications
- Stylus type
- Conical
- Tracking angle
- 23°
- Cartridge weight
- 5,5 g
- Dynamic compliance
- 14 μm/mN
- Frequency response
- 10 - 20 000 Hz +/- 2dB
- Cartridge principle
- MM (Moving-Magnet)
- Tracking force range
- 1,8 - 2,2 g (mN)
- Output voltage at 1
- 3,8 mV (3,54 cm/sec) kHz
- Tracking ability at 315hz
- 70 μm
- Tracking force recommended
- 2,0 g (mN)
- Recommended load resistance
- 47 kΩ
- Height stylus tip to top mounting surface
- 18,2 mm
Active listings (0)
Similar but better
Matched by the Audiophilia engine on character, specs and market position.
Peers
Pro-Ject Audio Systems · cartridges
Pick it MM 5
Price on request
- A close peer to this component
Pro-Ject Audio Systems · cartridges
Pick it PRO
Price on request
- A close peer to this component
Pro-Ject Audio Systems · cartridges
Pick it MM EVO
Price on request
- A close peer to this component
Pro-Ject Audio Systems · cartridges
Pick it PRO Balanced
Price on request
- A close peer to this component